First, determine the location of the bathroom cabinet B […]
First, determine the location of the bathroom cabinet
Before laying floor tiles and wall tiles, it is necessary to determine the installation position of the bathroom cabinet. Since the bathroom cabinet needs to be drilled in the wall, and there are two holes, the water inlet hole and the drainage hole, once the installation is completed, it cannot be changed at will. Therefore, it is very important to confirm the installation position of the bathroom cabinet. In order to avoid mistakes, the designer should design the position of all sanitary ware in the bathroom in advance to avoid mistakes during installation.
Second, see the layout of water and electricity pipelines
Since it is necessary to drill holes in the wall with an electric drill during installation, and water pipes and wire pipes are arranged on the wall of the bathroom, all, before drilling holes, you need to confirm the layout of the pipeline diagram and wiring diagram. It is necessary to knock out the tile repair, which will cause unnecessary losses.
Three, bathroom cabinet height
The installation height of the bathroom cabinet must also be paid attention to. The standard installation height of the general bathroom cabinet is 80-85 cm, which can be calculated from the floor tile to the upper part of the wash basin. The specific installation height needs to be determined according to the height and usage habits of family members, but the bathroom cabinet The height cannot be lower than 80 cm, and it is best to install within a certain height range. In addition, there should be a moisture-proof board at the bottom when the bathroom cabinet is installed to avoid excessive ground water vapor affecting the normal use of the bathroom cabinet.
Fourth, the main cabinet installation
When installing the wall-mounted bathroom cabinet, you need to select the positioning holes first, punch holes on the wall with an impact drill, install the plugs in the wall-mounted accessories into the holes, and then use self-tapping screws to lock the cabinet and the wall. . It can also be installed with expansion bolts. The installation method is the same. You need to drill the brick holes with impact first. After the cabinet is installed, align the basin with the wooden vase of the cabinet and adjust it to level. When installing the floor-standing bathroom cabinet, you need to screw the cabinet foot components on the fixing piece through the double-ended screw, and then put the cabinet in a proper position, and try to make the cabinet feet close to the outside, so that the entire cabinet body is evenly stressed.
